Prerequisites for installation and use:

• Enki Application* + Enki Box or Enki Connect Box / Essentiel b Connect Box

* Prerequisites for the Enki application: Internet access and a phone with minimum operating system: Android: 7 / iOS: 15

Communication protocol:

• Zigbee

Available country:

• France**

**Essentiel b Connect Box available only in France

State feedback available: 

• Yes

Alexa voice control: 

• Not direct, but possible via manual scenarios

Google Home voice control: 

• Not direct, but possible via manual scenarios

Article contents:

• Technical description

• Product functionality in the ENKI application

• Product view

• What does the radiator screen status mean?

• How to calibrate my radiator?

• How to reset my device?

• Technical documents / user manual

Technical description:

• Type: Electric heating (750, 1000, 1500, or 2000W)
• Requires Enki box: Yes / ENKI Box V1 - ENKI Connect Box
• State feedback: Yes
• Model: PVA-029 board
• Hardware: Rev. 0
• Power: 10 dBm
• Transmission: 2.4 GHz to 2.485 GHz
• Protocol: Zigbee
• Operating temperature range: 0°C to +40°C
• Powered by: 230 V
• Description:
  • Aluminum cast radiator with flat elements. Side cladding cheeks, 1 side cheek on one side
  • High-performance mineral oil, maintenance-free
  • High resistance anti-corrosion protection by 11 treatment baths with cataphoresis.
  • Very long-lasting epoxy paint, uniform paint on all radiator faces
  • Safety guaranteed by thermal limiter
  • Each Alcantara is checked at 14 manufacturing stages
• Wall projection: 106 mm
• Regulation:
  • Ultra-precise room thermostat to 1/10th of a degree
  • Backlit digital LCD display
  • 1 free weekly user program and 5 pre-recorded programs
  • Digital consumption indicator
  • Child lock system
  • Window open/close detector
  • Centralized time programming via 6 pilot wire commands
  • Low standby consumption (0.5 W)
  • Remotely controllable via the box and ENKI application

Product functionality in the ENKI application:

Control page	Settings

Product view:

What does the radiator screen status mean:

Not paired with ENKI box		Searching for signal	Paired with ENKI box

Heating in progress	Override activated (Manual mode)

How to calibrate my radiator?

SETPOINT TEMPERATURE CALIBRATION:

If after several days of operation of your radiator you notice a difference between the temperature measured in your room and the temperature programmed on the device, you can calibrate your radiator in increments of 0.1°C by following the procedure below.

How to reset my device?

RESET TO FACTORY SETTINGS (RESET)

When your control interface is not locked, you can return to the original settings at any time. The device then restarts in frost protection mode.

Technical documents / user manual