* Prerequisites for the Enki application: Internet access and a phone with minimum operating system: Android: 7 / iOS: 15

Article content:

Technical description:

Roller shutter module	Connect Rev Shutter switch:

Type: Embedded connected module for roller shutter Requires Enki box: Yes / ENKI Box V1 State feedback: No Protocol: DiO 1.0 Frequency: 433.92 MHz EIRP: 3 mW Transmission distance: 50 m (in open field) Max. 32 associated transmitters Operating temperature: 0 to 35°C Power supply: 220 - 240 V ~ 50 Hz Max power: Resistive load 500W Dimensions: 48 mm x 48 mm x 24.5 mm Usage: Indoor only	Type: Connected switch for roller shutter Requires Enki box: Yes / ENKI Box V1 State feedback: No Frequency: 433.92 MHz + Wi-Fi 2.4 GHz (Not compatible with ENKI, only DiO One non compatible with ENKI) Radio protocol: DiO 1.0 Radio frequency: 433 MHz Transmission range: 50m (in open field) Power supply: 220 - 240V - 50 Hz Voltage: Max 2 x 600W Operating temperature: 0 to 35°C Indoor use: IP20 EIRP: max. 0.7 mW Dimension: 85 mm x 85 mm x 37 mm Wiring: wired Control type: Up / Down

Roller shutter module:

Red LED slowly blinking after pressing the button	Red LED slowly blinking then blinks twice quickly (The shutter may perform a quick back-and-forth movement, but this is not mandatory) before stopping
Searching for receiver pairing signal in progress.	Signal reception confirmation during search

Connect Rev Shutter switch:
Switch states related to the Enki ecosystem:

Light green slowly blinking	Light green slowly blinking to two quick light green blinks.
433 MHz listening mode activated Ready to pair or unpair a new input. (Home automation box or 433.92 MHz remote control)	Command detected after entering listening mode Association or dissociation confirmation of the home automation box or 433.92 MHz remote control

Switch states not related to the Enki ecosystem:

Red rapidly blinking	Red steady	Blue blinking	Blue steady then white steady	Purple steady	Green blinking
Wi-Fi listening mode activated Ready to connect the switch to a Wi-Fi network via the native application	Disconnected The switch is not connected to the Wi-Fi network via the native application	Connected The switch is properly connected to the Wi-Fi network via the native application	Connected The steady blue indicates that the switch is properly connected to the cloud via the native application. After a few seconds, it changes to steady white	The switch's Wi-Fi is disabled	Connected Update in progress via the native application


Control page	Settings