---=== GENERAL CHARACTERISTICS ===---

• Power Supply: 220-230 V - 50/60 Hz
• Maximum Power Consumption: 600 W (with remote lighting 500 W)
• Operating Climate Conditions: -20° C / +60° C - IP 20
• Radio Frequency: 868 - 870 MHz, < 25 mW
• Number of Memory Channels (One-way Commands): Total/Partial Opening Command: 30,
• Auxiliary Output Command: 4, Integrated Lighting Command: 4
• Programming Interface: 4 buttons – 12 indicators

---=== CONNECTIONS ===---

• Safety Cell Input: Dry contact: NC, Photoelectric Cells TX/RX – Bus Cells - Reflex Cell
• Wired Command Input: Dry contact: NO
• Orange Light Output 24V - 15 W
• Remote Lighting Output: Dry contact, 230 V – 500 W max, i.e., 5 compact fluorescent or LED lamps, or 2 low voltage LED power supplies, or 1 halogen light 500 W max
• 24 V Controlled Power Output: Yes, for possible autotest of photoelectric cells TX/RX
• Accessory Power Output: 24VDC (28VDC max / 22VDC min) - 400 mA max
• Remote Antenna Input: Yes, compatible io antenna (Ref. 9013953)
• Backup Battery Input: Yes, compatible 9.6V battery pack (Ref. 9001001), Autonomy: 24 hours; 3 cycles depending on door, Charging time: 48 h

---=== OPERATION ===---

• Forced operation mode: By pressing "+" and "-" buttons before auto-learning
• Independent control of remote lighting: Yes
• Lighting delay (after movement): 60 s
• Automatic closing mode: Yes, short or long closing delay
• Orange light warning: 2 s in sequential mode with closing delay
• Partial opening command: Yes
• Soft start: Yes
• Closing slowdown zone: Programmable, 3 possible values

---=== GENERAL CHARACTERISTICS ===---

• Power Supply: 230 V - 50-60 Hz
• Electrical Insulation: Class 1
• Maximum Motor Power: 230 V - 1250 W
• Protection Fuse for Motor and Integrated Lighting: 5 AT - 250 V - replacement fuse provided
• Operating Climate Conditions: -20° C / +60° C - IP 20
• Radio Frequency: Somfy io 868 - 870 MHz <25 mW
• Number of Remote Controls Memory: 30

---=== CONNECTIONS ===---

• Power Supply Cable: 2 m - IEC Plug (phase-neutral-ground)
• Integrated Courtesy Light: LED lamp E14 - 1.4 W - 230V
• Safety Inputs: 3 inputs for wired safety edge (optical and resistive), Anti-fall device, Photoelectric cells
• Auto-test Output for Safety Devices: For cells
• Wired Command Input: Dry contact NO - sequential operation
• Orange Light: 24V - 4W max.
• Alarm Siren Output: Yes

---=== OPERATION ===---

• Control Buttons: Up-Stop-Down buttons on the front panel
• Automatic Closing Mode: Yes
• Maintenance Assistance: Real-time status with 5 indicators

• Protection Index: IP 55
• Weight: 0.15 kg
• Dimensions (LxH): 95 mm x 110 mm
• Radio Frequency: io 868-870 MHz
• Power Supply: DC - RGE 11 - 24V
• Built-in Manual Override Option: No
• External Manual Override Option: No
• Removable Cable: No
• Number of Wires per Cable: 2
• Wire Section: 0.75 mm²
• Minimum Operating Temperature: -20 °C
• Maximum Operating Temperature: 70 °C

Dexxo 800 Smart io

Part	Description	Comment
1	Set Indicator	At first power-on, learning not done   Learning in progress   Learning completed   Electronic fault (motor thermal, ...)
2	Prog Button	Radio reception   Confirmation of radio command point memorization   Waiting for radio command point memorization
3	PROG Button	Memorization / erasure of radio command points
4	SET Button	Press 0.5 s: enter and exit the settings menu  Press 2 s: trigger auto-learning  Press 7 s: erase auto-learning and parameters  Interrupt auto-learning
5	Minus Button	Before auto-learning, close door by holding button Interrupt auto-learning During settings, modify parameter value
6	Plus Button	Before auto-learning, open door by holding button Interrupt auto-learning During settings, modify parameter value
7	Settings Indicators	P0: Operating mode P1: Garage door speed P2: Slowdown zone P3: Obstacle detection sensitivity P4: Photoelectric cells Px: Door type
8	Detachable Terminal Block	230V Power Supply
9	Detachable Terminal Block	Auxiliary Output
10	Detachable Terminal Block	Photoelectric Cells
11	Detachable Terminal Block	Orange Light
12	Low Voltage Power Input 9.6V	Compatible 9.6V Batteries
13	Detachable Terminal Block	Wired command point, photoelectric cells, wicket contact
14	Detachable Terminal Block	Remote Antenna
15	Photoelectric Cells Indicator	Normal operation   Autotest in progress   Detection in progress / Permanent fault
16	Not used
17	Wicket Contact Indicator	Wicket contact open
18	Wired Command Indicator	Command activated
19	Integrated Lighting

ROLLIXO io

Access Receiver Compatible io

Factory Mode.

Learning not done. First power-on of the device.

Learning in progress.

Searching for learning.

Learning completed.

Device detected, learning successfully completed.

Fault. 

Electronic fault (Thermal, motor, ...)

Radio Reception.

Receiving a radio frame from a device.

Waiting for memorization.

Searching to register a radio command point

Memorization confirmation.

Radio reception confirmation for memorizing a radio command point.

Normal operation.

Normal use of the motorization.

Autotest in progress.

Autotest running to detect anomaly.

Detection or fault

Detection in progress or permanent fault.

Wicket contact open.

Detection of open wicket contact.

Command activated.

Detection of an activated command

Searching.

Searching for a radio device.

Registering command.

Registering a radio device after search. Or radio frame received from a known transmitter.

No movement possible.

Anti-fall not connected or no jumper on connector if anti-fall connected with motor common. Anti-fall triggered.

Motor fault. No movement possible.

Motor miswired or Anti-fall triggered (when anti-fall connected with motor common) or motor thermal protection activated or motor faulty or fuse blown.

Waiting for adjustment.

Waiting for motor adjustment for end stops.

Safety edge fault.

Opening possible, but closing by holding button in front of door.

Radio interference on safety edge transmitter.

Opening and stop operation. Closing by holding button in front of door: closing movement will resume automatically when radio interference disappears.

End of battery life of safety edge transmitter.

Opening possible, but closing by holding button in front of door.

Obstacle detected.

Obstacle cleared by automatic partial opening

Cells fault or Cells connector bridged

Opening possible, but closing by holding button in front of door, or 

Obstacle detected.

Obstacle cleared by automatic full opening.

Vacation mode active.

When pressing a key on the keypad or remote control, indicators blink: Vacation Mode is active. The product works, but it is impossible to use the keypad or remote control (depending on dipswitch 5 position) to control.

Searching.

Waiting for radio device connection.

Radio command detected.

Radio device detected and signal recorded.