The heating control screen via the pilot wire allows you to easily control and adjust the temperature of your radiator.
Select the heating control mode
The Enki app offers four distinct modes to adapt the behavior of the heating device to your needs:
At home mode
To simplify the management of your heating on a daily basis, activate "At home" mode so that the device automatically applies the general schedule already defined in the central "Heating" section of your Enki app. To do this, add your equipment to modes and schedules so that it can follow the overall control.
Equipment schedule
To adapt thermal comfort to the specific characteristics of the room where this equipment is located, select "Equipment schedule" mode so that the device follows the individual, customized schedule you have configured for it.
Manual mode
To adjust the temperature occasionally according to your current needs, switch to "Manual" mode to maintain a fixed setpoint until your next change.
Adjust the temperature and check the heating status
Adjusting the setpoint
To set the target temperature that your heating must reach and maintain in the room, use the rotary slider directly on the screen. This component is inactive if an override is in progress on the equipment; you must cancel the override in order to take control.
Easily adapt your heating routine to your daily habits by selecting the ideal mode on your screen: apply your reference temperature with "Comfort" mode, fine-tune it if necessary with "Comfort - 1" or "Comfort - 2" modes, switch to "Eco" mode to lower the temperature during short absences, activate "Frost protection" mode to protect your pipes during the winter, or turn the device off completely with "Off" mode.